Micromod Micro-DCI: 53SL5100A Single Loop Controller Manual do Utilizador descarregar pdf (Página 37)

Single Loop Process Controller Instruction Manual

Front Panel 29

3.3.2 Altering a Datapoint

The following procedure illustrates how to enter EMODE and use the configuration function to alter the

contents of datapoint B000 (B0) with a 97. Entering a 97 in B00 invokes the display test which strobes the

display matrix dots on and off at 5 second intervals (approximate). When off, a perimeter of dots still

remains lit. Figure 3-11 and Figure 3-12 are display test illustrations that support the procedure provided in

Table 3-3. It should be noted that EMODE has a 20 second timeout if it is accessed and its functions (e.g.,

configure or display) are not used.

Figure 3-10. A1 PERCENT

Table 3-3. Procedures to Alter a Datapoint

Step Press

Shift

Result

Press to

Locate

Target

Char.

Result

MODE

Puts instrument in EMODE.

If CONFIGURE does not appear, press F2.

Displays entry line: POINT .

(If the prompt KEY? appears, see Table 3-5.)

↑ B

Puts B on entry line: POINT .B.

← .B∆↑ 0

Shifts B and puts 0 on entry line: POINT .B0.

← .B0∆ ↑ 0

Shifts B0 and puts 0 on entry line: POINT .B00.

Displays contents of B00 (0).

hold→ .

locator

B00 contents shifted right; only locator point

remains on the entry line: B00 .

↑ 9

Puts 9 on entry line: B00 .9.

← .9∆↑ 7

Shifts 9 and puts 7 on entry line: B00 .97.

Enters 97 in B00 to start the display test.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 151 152

Sem comentários

Micromod Micro-DCI: 53SL5100A Single Loop Controller Manual do Utilizador Página 37